JN-S series (15A/20A) electric quantity display Edition
2. this controller has 12V, 24V automatic recognition design.
3. the controller has the advantages of light and time control (lamp type).
4. the control has over charge, over discharge, over current, short circuit, reverse connection and other protective measures.
5. the controller has power down protection (that is, after the button is adjusted, the controller power down, it will save the last adjustment of the data).
6. with strong charge, balanced impulse, float three PWM regulating charging mode.
7. the controller has lightning protection design, prevent the electric current impact with a soft start function

led lamp | Instruction content | state | function |
load | green led | Long bright | Loads are output |
|
|
Long out | Load without output (electric) |
|
|
flashing | No output load (undervoltage) |
battery | red led | Long long bright part (bright) | Battery charge (25%-100%) |
|
(4) |
Mobile flash |
Charging status |
The product installation size and connection:
1, the installation environment: installed in a dry ventilated place.
2, the size of the installation (as shown in the figure below) note: fixed screw M3 * 10 specifications
3, connection method (as shown in figure)
A, first to answer the battery (positive) on the left connected correctly, digital tube appeared with the words' 1 'or' 2 ', '1' representative to 12 v system, '2' representative to 24 v system), after A few seconds, the LOAD, and power the light show. (street lamp type LOAD during the day is long, under voltage, over pressure LOAD long peg). Otherwise check the line.
B, then the panels (positive) on the left and right power monkey show began, into the charging status. Otherwise check the line.
C, the final load (light bulbs, the anode) on the left connected correctly, the light bulb glow (street lamp type long nights out, undervoltage, overvoltage out). Otherwise check the line.
Note: the ABC must be connected in sequence, otherwise it will damage the controller.
Rated voltage | 12 v, 24 v auto |
Strong charging pressure | 14.8V/29.6V |
Equilibrium charging | 14.5V/29V |
Float charging pressure | 13.7V/27.4V |
Under voltage | 10.8V/21.6 |
Under recover voltage | 13V/26V |
Maximum charging current | 5A/10A/15A/20A |
Maximum load current | 5A/10A/15A/20A |
Controller protect | overcharge, over-discharge, over-current, short-circuit, reversed |
Charging way | PWM charging way |
Working temperature | -40-60℃ |
Weight (gross) | 200g |
Product size | 136*92*31mm |
Protection level | IP56 |
- Previous:JCS (40A 12V/24V/48V) home system solar controller
- Next: JCS (30A 12V/24V/48V) home system solar controller