JN-S series (5A/10A) electric quantity display Edition

Product function
1. This controller has the design of household and street lamp.
2. this controller has 12V, 24V automatic recognition design.
3. the controller has the advantages of light and time control (lamp type).
4. the control has over charge, over discharge, over current, short circuit, reverse connection and other protective measures.
5. the controller has power down protection (that is, after the button is adjusted, the controller power down, it will save the last adjustment of the data).
6. with strong charge, balanced impulse, float three PWM regulating charging mode.
7. the controller has lightning protection design, prevent the electric current impact with a soft start function
Product description

Status indication
led lamp Instruction content state function
load green led Long bright Loads are output

Long out Load without output (electric)

flashing No output load (undervoltage)
battery red led Long long bright part (bright) Battery charge (25%-100%)


Mobile flash

Charging status

The product installation size and connection:

1, the installation environment: installed in a dry ventilated place.

2, the size of the installation (as shown in the figure below) note: fixed screw M3 * 10 specifications

3, connection method (as shown in figure)

A, first to answer the battery (positive) on the left connected correctly, digital tube appeared with the words' 1 'or' 2 ', '1' representative to 12 v system, '2' representative to 24 v system), after A few seconds, the LOAD, and power the light show. (street lamp type LOAD during the day is long, under voltage, over pressure LOAD long peg). Otherwise check the line.

B, then the panels (positive) on the left and right power monkey show began, into the charging status. Otherwise check the line.

C, the final load (light bulbs, the anode) on the left connected correctly, the light bulb glow (street lamp type long nights out, undervoltage, overvoltage out). Otherwise check the line.

Note: the ABC must be connected in sequence, otherwise it will damage the controller.

Rated voltage 12 v, 24 v auto
Strong charging pressure 14.8V/29.6V
Equilibrium charging 14.5V/29V
Float charging pressure 13.7V/27.4V
Under voltage 10.8V/21.6
Under recover voltage 13V/26V
Maximum charging current 5A/10A/15A/20A
Maximum load current 5A/10A/15A/20A
Controller protect overcharge, over-discharge, over-current, short-circuit, reversed
Charging way PWM charging way
Working temperature -40-60℃
Weight (gross) 200g
Product size 136*92*31mm
Protection level IP56

Data download

Online consulting
Phone number:
QQ number:
Verification Code:
Go Back
Online Service
OnlineOnline consulting
Contact US:
0551 - 65372576